CRM Mitchell1 2018-03-27T22:01:09+00:002006 Land Rover LR3 CRM Mitchell1 2018-03-27T22:01:09+00:00
- AIR CLEANER/ELEMENT – REPLACE – ENGINE OIL – REPLACE ENGINE OIL FILTER – REPLACE ANTI-CORROSION VEHICLE INSPECTION – PERFORM – [Perform Anti-corrosion inspection on vehicle exterior.] BRAKE CALIPERS – INSPECT – [Remove all road wheels before inspecting brake components. Check for leaks.] BRAKE DRUM OR DISC – INSPECT – [Remove all road wheels before inspecting brake components. Check condition.] BRAKE PADS – INSPECT – [Remove all road wheels before inspecting brake components. Check for wear and signs of damage.] COOLANT LEVEL – INSPECT – [Check/top up coolant level; check specific gravity.] DOOR HINGES and LOCKS – INSPECT – [Check operation of all door/flap/hood checks and catches.] DRIVE BELTS – INSPECT ELECTRICAL SPEED SENSOR HARNESSES – INSPECT – [Inspect electrical harnesses, routing and connections.] EXHAUST SYSTEM – INSPECT – [Check for leaks, damage and abrasion points.] FLUID and LUBRICANT LEVELS – INSPECT – [Brake, Power Steering, Windshield Washer (including summer/winter cleanser) Fluids.] FLUIDS – INSPECT – [Check for fluid or air leaks.] FUEL SYSTEM – INSPECT – [Inspect fuel, hydraulic and fluid pipes, hoses and unions.] HORN OPERATION – INSPECT LIGHTING SYSTEM – INSPECT – [Check operation of all lights.] PARKING BRAKE – INSPECT – [Check adjustment of electronic parking brake.] PAS HOSES – INSPECT PAS LINES and CONNECTIONS – INSPECT SEAT/SAFETY BELTS – INSPECT – [Check condition and security.] STEERING SYSTEM – INSPECT SUSPENSION SYSTEM – INSPECT TIRES – INSPECT – [Check tire presure, damage and tread depth.] WARNING SYSTEM OPERATION – INSPECT – [Check operation of all lights, warning indicators (if equipped) and horn.] WINDSHIELD WIPER and WASHER SYSTEMS – INSPECT – [Check operation of both front and rear (if equipped) wiper washer system. Add fluid if necessary.] WINDSHIELD WIPER BLADE INSERTS – INSPECT DOOR HINGES and LOCKS – LUBRICATE WHEEL CENTERS – LUBRICATE – [Refit wheels to oppisite sides of the same axle, unless vehicle is fitted with unidirectional tires.] SERVICE INTERVAL INDICATOR/DISPLAY – RESET – [Reset Service Indicator at every service.] SILICON SPRAY – APPLY – [Apply silicon spray to all door edge seals.] TIE ROD ENDS – CHECK – [Check torque; tighten to 76 Nm (56 lbf ft).] VEHICLE – ROAD-TEST – [Conduct road test; select LOW range gears and drive the vehicle 3-4 vehicle lenghts, then reselect HIGH range gears.]
- Replace rear brake pad linings, wear sensor, and rear brake rotors. Removed and replaced brake calipers and lubricated slide mechanisms. Check and fill brake fluid. Bleed air from system. Road test vehicle.
Kris N. gave our service a 5 star review on 3/1/2018